Hardware Support

Renesas Support from Embedded Coder

Generate code for Renesas processors.

MATLAB Coder, Simulink Coder, and Embedded Coder generate ANSI/ISO C/C++ code that can be compiled and executed on Renesas processors. Embedded Coder lets you easily configure the code generated from MATLAB and Simulink algorithms to control software interfaces, optimize execution performance, and minimize memory consumption.

Supported Hardware

MATLAB Coder, Simulink Coder, and Embedded Coder generate ANSI/ISO C/C++ code that can be compiled and executed on any Microcontrollers, including the devices listed below:

  • RH850
  • RX
  • RL78/78K
  • SuperH
  • H8/H8S
  • R8C/H8 SX
  • M32R/M16C
  • V850

You can also use Embedded Coder to customize the generated code specifically for Renesas processors using published APIs and reference examples. For example, you can generate processor-specific (non-ANSI) optimized code and perform processor-in-the-loop (PIL) testing with execution profiling.

For RH850 processors, you can use Embedded Target for RH850 Multicore which automatically build code for multicore implementation and PIL simulation from Simulink model.

For RX, RL78 and other MCUs, you can use Embedded Target for Renesas CS+ for PIL simulation.

And also, Peripheral IP (Intellectual Property) models of Renesas MCU are ready for model-in-the-loop (MIL) simulation on Simulink.

MathWorks does not offer an Embedded Coder Hardware Support Package for the devices listed on this page. Third Party Connection hardware and software products may exist, and MathWorks Consulting Services is available to aid with hardware integrations.